Apron decal Gottlieb System 1

Lower playfield apron cardholder decal for Gottlieb System 1 and electromechanical pinball machines.

Red & blue printed on clear vinyl. Repaint cover base in gloss white.

Reference:

• D-13467-1E cardholder

Installation Instructions:

After stripping and repainting the metal cardholder apron (use a high quality spray paint), allow the base coat to cure for at least 24 hours.Make sure the surface of the apron is clean - no dust, oil, wax, fingerprints.Position the decal on the apron and mark position with masking tape.Use a spray bottle to wet the apron surface with water and a small amount of dish detergent. This allows re-positioning and air bubble removal before the adhesive is set.Place decal face down and carefully remove adhesive backing. Don't allow dust or dirt to contaminate the adhesive.Apply the decal to the apron surface and adjust position.Lay a piece of paper on top of the decal to prevent squeegee scratches. Squeegee the decal from the center area outward and push air bubbles out to the edges.Allow 24 hours to dry. Fogging of the clear adhesive areas may occur in certain climates but will dissipate in several days.After drying, trim holes as necessary with a hobby knife.